- Electro-Pneumatic Spraying
- Spray nozzle for wide area coverage
- Spray angle adjustment knob
- Easy load & non-stick piston
- Comes complete with integral gun stand.
- Ventilated heater housing and silicone rubber nozzle shroud PTFE barrel and power-on warning light.
The TEC 6300 is a unique, economic, spray applicator that makes hotmelt spray applications affordable for everyone.
Built to a very high standard, the TEC 6300 is a totally self contained unit, requiring only compressed air and electricity to operate. There are no expensive bulk tanks or fragile heated hoses to go wrong.
The TEC 6300 takes only 10 minutes to warm up from cold and is fast and safe to reload using 43mm TECBOND adhesive cartridges.
Just pull the trigger and the adhesive is melted on demand by the powerful 500 watt heated melt chamber. Adhesive output is controlled by adjusting the air pressure, and the spray pattern is varied by using the rear mounted spray control knob (easy to use by both left and right-handed operators).
The TEC 6300 is a high output, hand-held industrial hotmelt spray glue gun. Capable of dispensing up to 4.2 kilos of molten hotmelt per hour, the TEC 6300 is ideal for covering areas up to about one metre square at a time. It can also be used on heat sensitive substrates such as expanded polystyrene and other plastic foams. A range of spray adhesive formulations is available to suit most applications.
The TEC 6300 spray system is solvent-free and non-toxic, so there are none of the environmental problems that are often associated with other spray adhesive applicators.
Built to meet all the latest European Electrical Safety Standards, the TEC 6300 comes complete with an integral gun stand, suspension ring, full operating instructions and a one year guarantee.
The TEC 6300 range includes a high temperature version (please note, these tools are made to order and have the reference 6300HT).
|Heater||2 x 250W stainless steel cartridges (total 500 Watts)|
|Temp. Control||Pre-set thermostat 195ºC & safety thermal fuse|
|Power Cable||3m rubber sheathed, with plug fitted + air hose with reinforced heat resistant sheathing OR 6m/12m electro-pneumatic extension cable options.|
|Melt Rate||Up to 4.2 kg/hr, depending on adhesive & temperature (average output across the range is 3.6 kg/hr)|
|Coverage||Between 13m² and 50m² per kilo, depending on whether the spray pattern has been applied heavily or lightly|
|Adhesive Size||TECBOND 43mm glue slugs|