Curecon A Range

Name Code Chemical Type Base Type Size Type Desc  
CURECON A 20L Curing Compound 185020-0020 - Acrylic-Water 20 Curing Compound Order
CURECON A 200L Curing Compound 185020-0200 - Acrylic-Water 200 Curing Compound Order
CURECON A 1000L Curing Compound 185020-1000 - Acrylic-Water 1000 Curing Compound Order

Overview

Product Description

CURECON A acrylic water-based curing compound is a Class D, Type 1 curing compound for use on new concrete that facilitates maximum moisture retention through the curing period to maximize concrete strength & durability.

CURECON A, when applied by the correct method and at the recommended application rate, leaves a dried film, which is not particularly obvious. This film has minimal darkening on exposure to sunlight. CURECON A is based on an acrylic resin combined with other additives.

Product Advantages

  • Compatible with most after trades
  • Environmentally acceptable
  • No ventilation requirement
  • No stringent safety requirements
  • Efficient curing of the concrete assists the development of strength, abrasion resistance, and durability
  • Reduces the likelihood of cracking or dusting at the surface
  • Easy to use, eliminates messy water curing or polythene film
  • Low odour

Design Criteria

The coating should be applied at a coverage rate of 5m2/litre. To achieve the correct curing properties and moisture retention according to AS/RTA standards, Curecon A must be applied at the above-stated coverage rates. Curecon A does not contain a fugitive dye so care must be taken to ensure a uniform application is achieved. Curecon A dries as a clear film on the surface

Properties

Colour Milky Fluid
Viscosity >0.050Pa.
Specific Gravity 0.95-1.0
Flash Point Not Applicable
Drying Time Approximately 1½ -2hours at 25°C

After this time the CURECON A will be shower resistant and will resist re-emulsification and consequential removal

Coverage 5m2/L (0.2litres/m2) using a spray applicator – do not brush
Application Equipment Low-pressure spray (preferred) or soft 10-15mm nap roller.
Thinning Nil – use as supplied
Clean Up Water when wet. Xylene, or Solvent 525 (allows re-emulsification with water) when dry.

Application Instructions

Mix prior to use. Ensure CURECON A is homogeneous. Curecon A should be evenly sprayed onto the surface over the freshly laid concrete as soon as possible after final trowelling. Ideally, Curecon A should be applied as soon as the surface bleed water has evaporated. In all cases, Curecon A should be applied at a coverage rate not greater than 5m2 per litre.

Note: CURECON A does not contain fugitive dye. Care should be taken to ensure CURECON A is applied in an even film over the entire surface area of the concrete.

Specifications

SKU 185020-0200
Shipping Weight 190 kg
Chemical Type Curing Compound
Base Type Acrylic-Water
Size 200
Type Desc Curing Compound

Documents

CURECON A SDS (MSDS)
CURECON A TDS (Technical Data)